-
2.01 Two Socket Cross
The two socket cross is designed to give a 90° joint between an upright and the middle rail of any rectangular structure such as guard rails.The upright should pass through the fitting.
For reducing Two Socket Cross’s, “Thru” refers to the through measurement & “Butt” refers to the butt measurement.
Technical Specification
-
2.02 Three Way Mid Corner
The three way mid corner is designed to give a 90° corner joint for the middle of any rectangular structure such as guard or mid railing.For reducing three way top corners, “Thru” refers to the through measurement & “Butt” refers to the butt measurement.
Technical Specification
-
2.03 Three Way Top Corner
The three way top corner is designed as a 90° corner joint.Normally used for the top corner of rectangular structures such as guard railings, hand railes or tennis courts.
For reducing three way top corners, “Thru” refers to the through measurement & “Butt” refers to the butt measurement.
Technical Specification
-
2.04 Two Socket Cross 30° – 45°
The two socket cross 30° - 45° is designed to give a variable joint between the upright and the middle rail.It can be used at any selected angle between 30° and 45°.
Normally used together with type MasterKlamp product type 1.07 for the top rail.
Technical Specification
-
2.05 Side Outlet Cross
The side outlet cross is designed to connect the upright with the horizontal tubes in three directions, all at 90° to the upright.The upright passes through the fitting.
Technical Specification
-
2.06 Four Socket Cross
The four socket cross is designed to connect the upright with the horizontal tubes in four directions, all at 90° to the upright.The upright passes through the fitting.
Technical Specification
-
2.07 Combi Socket Tee & Cross
The combi socket tee & cross is designed to join horizontal rails to the upright and also provides a socket to create a horizontal joint across the section.Normally used for shelving and pallet racking structures.
Technical Specification
-
2.08 Crossover 90°
The crossover 90° is designed to give a 90° crossover joint. Normally used on guard rails and other structures where a continuous horizontal rail is required.For reducing Crossover 900’s, “Thru” refers to the through measurement & “Butt” refers to the butt measurement.
Technical Specification
-
2.09 Clamp-on Crossover 90°
The clamp-on crossover 90° is designed to give a 90° crossover joint between two pipes.Because of the open-end construction it makes an easy add on fitting for existing structures.
Technical Specification
-
2.10 Adjustable Swivel Cross (set)
The adjustable swivel cross is designed to give a variable corner joint. It can be used at any selected angle between 90° and 180°.
Technical Specification
-
2.11 Two Socket Cross 0° - 11°
The two socket cross 0o—11o is designed to give a 90° joint between an upright and the middle rail of any rectangular structure such as guard rails.The upright should pass through the fitting.
Technical Specification
