-
L.1.02 Light Short Tee
The light short tee is designed to give a 90° butt joint between two pipes. This fitting cannot be used to join horizontal pipes within the fitting.
Technical Specification
-
L.1.04 Light Long Tee
The light long tee is designed to give a 90° butt joint between two pipes.This fitting should be used where a join is required between the horizontal pipes, as the sleeve holds two grub screws.
Technical Specification
-
L.2.01 Light Two Socket Cross
The light two socket cross is designed to give a 90° joint between an upright and the middle rail of any rectangular structure such as guard rails.The upright should pass through the fitting.
Technical Specification
-
L.2.08 Light Crossover 90°
The light crossover 90° is designed to give a 90° crossover joint.
Normally used on guard rails and other structures where a continuous horizontal rail is required.
Technical Specification
-
L.3.01 Light Elbow 90°
The elbow 90° is designed to give a 90° elbow joint. Normally used as the end joint for the top rail of guard railings etc.
Technical Specification
-
L.4.01 Light Base Flange
The base flange is designed as a wall fixation flange. Normally used as a wall or base flange, where only positional fixing is required.
Technical Specification
-
L.4.02 Light Railing Base Flange
The railing base flange is designed as a strong base flange to support vertical posts. The fixing holes in the base should be set in line with the applied load.
Technical Specification
